![]() You may also find posts from people who have installed our kits on along with community input on your issue. Make sure to do your final testing with the car RUNNING** If you are having any trouble with your installation, please feel free to Contact Us. Your car must be RUNNING for proper operation of the modules. **These modules require a solid 12V to operate correctly.The light sockets are labeled the same: inside light L1, middle L2, outside light 元 and all the wiring connections remain the same. Your drivers side module install is the same as what you have just accomplished, with one minor change.Module can be tucked into various positions behind the tail lens. Re-connect any loose light sockets to lens and be sure to tape all connections very well.Taillights Sequential LED With Clear Lenses Renegade Series 2015 Euro-Style Black Housing Pair Mustang 2015-2023. Attach the remaining blue wire from the module to the two red/white wires coming out of harness. CJ Classics Taillight Wiring Harness USA Made Fastback 1966.Attach the red wire from the module to the wire still attached to 元. Cut the red/white wire attached to the 元 socket.Attach the orange wire from the module to the wire still attached to L2. Cut the red/white wire attached to L2 socket.Attach one of the blue wires, does not matter which one, from the tail light module to the green with yellow strip wire coming from the new socket in the MAJOR cavity.Attach the brown wire coming from the new socket that is in the MINOR cavity to the green wire coming out of the wiring harness. 2005, 2006, 2007 Mustang Sequential 2008 Mustang GT/CS - Sequential Tail Mustang Sequential Tail Light Kit (05 Spyder ALT-YD-FM05V3-LED-SM - Black 2005.Attach the two black wires coming from the wiring harness that you just cut the black wire coming from the new socket that is in the GRD cavity and the black wire coming from the tail light module all together.You are going to attach the supplied socket to the harness in place of this one. Remove the socket labeled L1, cut all three wires attached to it as close to the socket as you can. Notice we have the sockets labeled L1,L2 and 元.Be sure to squeeze rubber grommet through hole so that it will come with assembly. Remove the 3 nuts holding the tail light assemply on, then gently pull the assembly away from the car. 2007 Ford Mustang LED Tail Lights Sort by 1 - 30 of 39 results Lumen® Chrome/Smoke LED 3rd Brake Light 0 1038849898 Ford Mustang 2007, Chrome/Smoke LED 3rd Brake Light by Lumen®, 1 Piece. Unplug the taillight harness connector from inside the car.FREE delivery Thu, Dec 8 on 25 of items shipped by Amazon. To remove push pins, use your screw driver to pop up the center cap. iJDMTOY OEM-Spec Red Lens 9-LED Rear Truck Bed Mounted Center Tailgate Running Light Bar, Compatible with 1999-2010 Ford F-250 F-350 F-450 DRW, Also Fit Other Truck/Pickup. Open your trunk and remove the rear tail light carpet/cover by loosening the 2 thumb screws and removing all 4 push pins.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |